2.2 prefinal2 - looisng WAN routes under load

Discussion in 'DD-WRT Firmware' started by dellsweig, Mar 26, 2005.

  1. dellsweig

    dellsweig Network Guru Member

    Greetings

    I got to spend this morning working from home - VPN tunnel into work with LOTS of X traffic through. Doing some load testing on some very graphcal stuff (HPOV).

    I also have 2 VoIP adapters (hard wired to the WRT54G) with QoS enabled, another WRT54G (WDS node) and 8 wireless computers connected into the network. I have a cable modem with 5000/400 service.

    Under load, at fairly frequent intervals (5 minutes) I will loose my internet connection. The router continues to function locally - I can still communicate with the other computers on the LAN as well as receive syslogs from the router. When I look at the routing table on the WRT54G, it seems my WAN route entries are gone. I can release and renew my routers public IP but the WAN routes are gone - hence no internet connectivity.

    On a reboot of the router, the routes are back, for a while. If I manually re-enter the routes, everything is fine - again for a while.

    I fell back to DDWRT 2.1c and the problem is gone

    Any ideas?? Anyone else seeing this??
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice