1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

802.1X auth using AP in client mode or bridge

Discussion in 'Networking Issues' started by emilus, Mar 24, 2005.

  1. emilus

    emilus Network Guru Member

    I want to run FreeRADIUS serwer to auth users in my network. My default configuration will be on wrt54g (openwrt with chilli) but now I just finished configure radus serwer and I want to test it. My test configuration is:
    1) D-Link dwl-900AP+ as AP. I configure it with WPA and address of my radius serwer.
    2) Linksys wet11 as client (bridge) and it is connected to ethernet card in my laptop.

    and this not working.
    Somebody know any links to documentation about how to configure client station with bridge to authorize with 802.1X.
    On linksys and d-link is the newest firmware instaled.

    Is possible to authorize clients which use wireless bridge?

    THX for any help
  2. howardp6

    howardp6 Network Guru Member

    The WET11 does not support a radius server, the WET54G and WET54GS5 do.
  3. emilus

    emilus Network Guru Member

    ... so it is problem that wet11 dos't support WPA??
    There is not WPA settings... I trying WEP but it not working...
    Ok... I try other client as bridge...
  4. emilus

    emilus Network Guru Member

    Is any wifi bridge (AP in client mode) which I can use as client in WPA network??
    I have clients who use D-Link DWL-900AP+ as a wireless client (or in bridge mode) to his computers and I want to run RADIUS to auth my users. I have WRT54G as AP and I want to run chilli to authorize clients. Somebody know that it works?
    Clients who using wifi cards can configure 802.11x to authorize in my network... but what about clients who use D-link AP ??
  5. howardp6

    howardp6 Network Guru Member

    The WAP54G supports WPA in bridge and repeater mode with firmware 2.08.

Share This Page