A little help please.

Discussion in 'Other Linksys Equipment' started by DevilWAH, May 16, 2005.

  1. DevilWAH

    DevilWAH Network Guru Member

    Hi guys.
    I am with zenasdl and have 8 static ip's.
    i trying to set it up so that each of my pcs has its own ip address and turn NAT of on my WAG54G v2.

    However when i try this nothing works.
    can any one give me a short guide as to how to set up publice ip on the WAG please. of is any one knows a website that will help point me in the right direction.
    thank you
    Aaron
     
  2. booly

    booly Network Guru Member

    you must define a manual routing table
     
  3. DevilWAH

    DevilWAH Network Guru Member

    ah that whould be a good idea!!
    at work i dont get to deal with the routing part of the network. so i having to do a bit of learning on that.
    i also assume that i will have to allow the router to be configered from out side the lan (from the publice addresses) . or else set up the pcs to work on to ip subnets
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice