About boardflag

Discussion in 'Tomato Firmware' started by old_navy, Apr 23, 2007.

  1. old_navy

    old_navy Guest

    What is default Tomato firmware v.1.06 boardflag setting for WHR-HP-G54?
  2. GeeTek

    GeeTek Guest

    Default = Boardflags=0x2758 = Pre-Amp active.
  3. Talon88

    Talon88 LI Guru Member


    What is the Default Value of Tx Power in mW,
    Is it 10mW or ~60mW-80mW......??


  4. GeeTek

    GeeTek Guest

    I would guess default to be around 125 mW. Maybe 200. It is very strong.
  5. Talon88

    Talon88 LI Guru Member


    After I dig thru many info, there are no real answer yet.
    Some say for WHR-HP-G54, 10mw is max safe, some say no more
    than 80mW.....

    I set it at 10mw at the moment to play safe until more
    solid answer from the FW Programer....

  6. GeeTek

    GeeTek Guest

    OH, you mean the gui setting. Yes, 10 is good. 15 more than plenty.
  7. nsumner

    nsumner LI Guru Member

    The default of the firmware is 10. If you go over 10 it seems to automatically disable the internal booster. I know on my unit (I have 2 units linked WDS which makes it easy to check the signal strength) increasing my power to 15 lowers my signal. Going to 80 makes it around the same as 10. Going under 10 lowers the signal.

    This seems to be the winning solution and still seems to be based on anybody actually doing testing the best setting found on the DD-WRT forums.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice