1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Access Point problems

Discussion in 'Tomato Firmware' started by freee, Mar 1, 2008.

  1. freee

    freee LI Guru Member

    After doing the basic setup to use my WRT54GL as an AP I'm able to access the internet but unable to access other computers on the LAN. I'm guessing its because the two router IPs are different. I've followed these steps:

    1) Disable the dhcp server service on the AP
    2) Plug in the AP to you wired network using one of the LAN ports (WAN won't work)

    However, the IP address for the AP is 192.168.1.1 and my primary router address is 192.168.0.1. I've tried changing the AP address to something else (192.168.0.2 or 192.168.0.50) with no luck...I'm unable to access the AP after the change and have to reset it.

    Any suggestions?
     
  2. FRiC

    FRiC LI Guru Member

    See your other post.
     
  3. Toxic

    Toxic Administrator Staff Member

    change the AP settings too: LAN 192.168.0.x and set the gateway to 192.168.0.1 amke sure your subnet mask is the same as the gateway ie. 255.255.255.0

    you can afaik disable the WAN in tomato (I know you can in the WRTSL54GS) if not just connect the AP via a LAN port to the gateway router and dont use the WAN port
     

Share This Page