1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Access Point + WDS

Discussion in 'Tomato Firmware' started by kennygone, Jul 24, 2009.

  1. kennygone

    kennygone Addicted to LI Member

  2. baldrickturnip

    baldrickturnip LI Guru Member

    WEP only I think
    WPA gets flakey -
     
  3. fyellin

    fyellin LI Guru Member

    I'm running WDS with WPA just fine.

    My main router's encryption is WPA/WPA2 Personal + AES. My "extension" router is set to WPA Personal + AES.
     
  4. RonWessels

    RonWessels Network Guru Member

    When setting up a WDS connection with encryption enabled, make sure to allow plenty of time for the routers to set up the connection. When I was playing with my two routers, it often took a few minutes before the WDS connection was established.
     
  5. kennygone

    kennygone Addicted to LI Member

    When I configure the second router to WDS only instead of Access Point + WDS it works.

    But both with Access Point + WDS doesn't work. Even if I wait some minutes.
     
  6. fyellin

    fyellin LI Guru Member

    Could you post a picture of your Network > Basic > Wireless section?
     
  7. kennygone

    kennygone Addicted to LI Member

    SSID and Shared Key are the same on both routers.
     

    Attached Files:

  8. kennygone

    kennygone Addicted to LI Member

    Don't ask me why but I tried it again like several times before and now it is working.:confused: :)
     

Share This Page