1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Accessing modem (ST516) via Shibby Tomato

Discussion in 'Tomato Firmware' started by i0's, Mar 8, 2013.

  1. i0's

    i0's LI Guru Member

    Just flashed my N66U with Shibby v107 AIO. Loving it so far.
    Figured out most of the things but cannot set it up to access my modem, Speedtouch 516 in bridge mode. Used to be able to coming from WRT54GL using Thibor.

    I put the below in Administration -> Scripts-> Firewall and save and rebooted the router, still no luck
    Any help.
  2. EpsilonX

    EpsilonX LI Guru Member

    Dunno bout Shibby's build, but I assume it's the same as Toastman's...
    There's a GUI option for it...

    Basic > Network > "Route Modem IP"
  3. i0's

    i0's LI Guru Member

    BINGO!!! That worked, didn't even have to put the above script! Thanks for the prompt reply.
    Thanks Shibby for this great FW!!!
  4. meazz1

    meazz1 Addicted to LI Member

    I am using Shibby 107 but my "router modem ip" is all 0's, the type is set to "DHCP".
    How do I get my modem ip address to show up?
  5. Dent

    Dent LI Guru Member

    It doesn't show up automatically. You need to replace the 0's with your modem's ip address and hit save at the bottom.
  6. meazz1

    meazz1 Addicted to LI Member

    I don't have static IP from the ISP, does the IP change automatically for DHCP IPs?

Share This Page