1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Acessing Tomato Gui in Wireless Bridge Mode

Discussion in 'Tomato Firmware' started by jchang7, Jun 1, 2007.

  1. jchang7

    jchang7 LI Guru Member

    I just reflashed my buffalo router with tomato firmware, and I am very impressed :).

    One quick question though, shoudl be pretty simple. I tried searching, but couldn't find anything (only a deleted post saying that they figured it out, but no solution was posted). Right now, my network is setup as follows:

    [modem] ---wired---> [router] ---wireless---> [bridge]
    modem: 192.168.0.1
    router: 192.168.1.1
    bridge: 192.168.11.1

    The tomato firmware is acting as the bridge in my network. I changed the ip addres of my bridge to be 192.168.11.1. Voila, I can not connect to my router through the bridge. The problem I am facing now is accessing the bridge. Is there any way to access the Tomato Firmware GUI again? Seems like it should be really simple, but I can't ping 192.168.11.1, or access it like I usually do.

    Any advice?
     
  2. GeeTek

    GeeTek Guest

    What is the IP address of the computer you are using to access the bridge at 192.168.11.1 ?
     
  3. jchang7

    jchang7 LI Guru Member

    192.168.1.116
     
  4. GeeTek

    GeeTek Guest

    Change the computer to 192.168.11.2 and it will access 192.168.11.1
     

Share This Page