Adding Victek mod to 1.23 help

Discussion in 'Tomato Firmware' started by maerd, Feb 26, 2009.

  1. maerd

    maerd Addicted to LI Member

    Hi there.

    I have a wrtg4g router that I can not physically access and which I can only connect to if its ip stays as

    I want to add the bandwidth mod by viktek but the install guide says that a nvram reset is required. Would this reset my ip to 192.....?

    If so is there any way of adding this mod with out the router loosing it's IP?
  2. maerd

    maerd Addicted to LI Member

    Can anyone shead any light on this?
  3. Victek

    Victek Network Guru Member

    Try to reboot instead.
  4. maerd

    maerd Addicted to LI Member

    Cheers for the help Victek. Worked just fine.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice