1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

ADSL2MUE "enable" password?

Discussion in 'Other Linksys Equipment' started by peja, Apr 27, 2005.

  1. peja

    peja Guest

    I can connect via SSH to ADSL2MUE and I know "root" password to login (console)

    I need "enable" password to configure my adsl box? Where I can get it?
    Beacause HTTP admin interface is very poor....

    Kindly Regards,
  2. Guyfromhe

    Guyfromhe Network Guru Member

    i don't know the enable password for it, if it's running IOS by default it's probably been locked down by your ISP...
  3. exxos77

    exxos77 Network Guru Member

    If you are familiar with linux, you don't need the "enable" password to do anything. Just SSH to your modem (root/admin by default) and use the "shell" command to be dropped to a BusyBox shell.

    You can then use any available linux command to do whatever you want. For example, when using the modem as a router (PPPOA mode), you can make the address the default server with:

    > iptables -t nat -I PREROUTING -i ppp0 -j DNAT --to-destination
    > iptables -D FORWARD -i ppp0 -j DROP
  4. TheLawyer

    TheLawyer Network Guru Member

    Well if someone needs to know, the password for the enable command is: Admin

    Make sure of the capital A then you can enter the admin setup, i have tried to disable the firewall_nat setting in the system menu, after that my whole modem needed a reset again, because it didnt do anything anymore...

Share This Page