1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Advanced routing problem

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by jprochal, Jul 8, 2008.

  1. jprochal

    jprochal Addicted to LI Member

    I have a problem with advanced routing. I set up static routing to subnet in different location which is connected throw T1 line.


    ISP -> Linksys RV082 < 192.168.0.0 > Cisco 2610 A< 192.168.5.0 > Cisco 2610 B < 192.168.1.0 > Hosts ( subnet 192.168.1.0 )

    Cisco A
    ip route 192.168.1.0 255.255.255.0 Serial0/0
    ip route 0.0.0.0 0.0.0.0 192.168.0.100

    Cisco B
    ip route 0.0.0.0 0.0.0.0 Serial0/0

    Linksys
    ip route 192.168.1.0 255.255.255.0 192.168.0.252

    I suppose that i have some bug in firmware 1.3.6 cause I can ping Linksys from 192.168.1.0 subnet, but I can't get access into the internet.

    Code:
    Cisco B>ping 192.168.0.100

    Type escape sequence to abort.
    Sending 5, 100-byte ICMP Echos to 192.168.0.100, timeout is 2 seconds:
    !!!!!
    Success rate is 100 percent (5/5), round-trip min/avg/max = 8/8/8 ms


    Code:

    Cisco B>ping 194.204.159.1

    Type escape sequence to abort.
    Sending 5, 100-byte ICMP Echos to 194.204.159.1, timeout is 2 seconds:
    .....
    Success rate is 0 percent (0/5)

    Code:


    Cisco B>traceroute 194.204.159.1

    Type escape sequence to abort.
    Tracing the route to 194.204.159.1

    1 192.168.5.1 8 msec 12 msec 8 msec
    2 192.168.0.100 4 msec 12 msec 8 msec
    3 * * *
    4 * * *
    5 * * *

    How I can set up internet for people in 192.168.1.0 subnet ?
     
  2. ifican

    ifican Network Guru Member

    can you please list the ip's of each interface on the routers that are connected to one another.
     
  3. sterner

    sterner LI Guru Member

    Try entering subnets into the Multiple Subnet settings in the Setup page of the RV.
     
  4. jprochal

    jprochal Addicted to LI Member

    Your answer helped me to solve my problem. Thank you for help ! :)
     

Share This Page