1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Alchemy 1.0 PPTP VPN only passing certain types of traffic.

Discussion in 'Sveasoft Firmware' started by paulb444, May 3, 2005.

  1. paulb444

    paulb444 Network Guru Member

    After connecting w/ XP over VPN to my linksys, I am only able to do a few network actions on the linksys LAN. I can ping, http over any port, pull up a microsoft share list on a computer, but I am not able to access a shared folder, or use any remote software, such as VNC or DameWare.

    I imagine there is some sort of routing issue--TCP vs. UDP, or some firewall issues?

    All advice is appreciated.

    Thank you.

    -- Paul
     
  2. knight14th

    knight14th Network Guru Member

    Check the cpu usage of your WRT while connected. I think that's the reason because there is not enough power to do more - that was my experience.
     
  3. paulb444

    paulb444 Network Guru Member

    95% CPU Utilization

    Yup, I am seeing 95% CPU Utilization with a client connected, but with no data xferring. Why does an idle connection require that much computation? If an idle connection requires 95%, how is this being offered as a feature?

    Is this a configuration issue, or are we just asking to much of this processor?

    -- Paul
     
  4. neosiv

    neosiv Guest

    I was having the same problem. Try disabling the Loopback under Administration. After I did that a lot of the problems I experienced cleared up.
     

Share This Page