Alchemy V1 and Client Mode

Discussion in 'Sveasoft Firmware' started by Merlin123, May 4, 2005.

  1. Merlin123

    Merlin123 Network Guru Member


    Maybe I'm a little bit too dumb to understand it... Just give me a hint.

    I want to use my WRT54G with Alchemy V1 to connect my PCs to a Hotspot.

    The hotspot has the following settings:
    SSID: blabla (just as an exaple)
    DHCP is active and will give my router an IP adress

    What settings must I make in the WRT54G to get an connection?
    What IP range can I use in my network?
    Only my router should be visible from outside.
    I've read the sticky topic with bridge and client, but I'm not sure what I have to do :(

    Can you give me any help?
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice