ASUS RT-N16: Maximizing the Transmit Power

Discussion in 'Tomato Firmware' started by crashnburn, Jun 2, 2012.

  1. crashnburn

    crashnburn LI Guru Member

    So, I skimmed quickly over this article:
    http://tomatousb.org/tut:increasing-wrt54g-transmit-power

    Is there a better article?

    Also, I found this little SECTION in the firmware.
    Transmit Power mW (range: 0 - 400, actual max depends on Country selected; use 0 for hardware default
    Currently its 107 because when I increase it further, the actual incoming signal became ZERO (as if it was TURNING OFF - I can check this again, but I tried that several times).

    Can you tell me which REGION settings will allow me to MAXIMIZE my TRANSMIT POWER.
    What VALUE should I keep my Transmit power?

    For now I have several Concrete structures that block and decrease signal. I am looking into getting new Antenna & extension cable but that is on PENDING for now due to other priorities.

    Do advise on which REGION settings and What TRANSMIT POWER.. I can / should use.

    Thanks.
     
  2. Elfew

    Elfew Network Guru Member

    Try Singapoure...

    And I dont recommend you to replace stock antennas... the results will be same
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice