1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Asus RT-N16 with USB serial console available (for sale)

Discussion in 'Tomato Firmware' started by koitsu, Jun 25, 2013.

  1. koitsu

    koitsu Network Guru Member

    Hi folks, just dropping by briefly (I'm still on hiatus, FYI).

    I have an Asus RT-N16 (original hardware revision, i.e. A0) which I've "modded" to a USB serial console port (plug directly into your PC + install FTDI driver + connect to the COM port at 115200 / 8N1 / no flow control and you're good to go). CFE is fully accessible/usable. Router has no problems/issues/etc. (all LAN ports work at gigE, WAN port works, wireless works / no signal issues) -- it used to be my primary home router.

    I'm getting rid of it because I need the cash (been unemployed for a little over a year) and since it has serial console figured I'd offer it to the community here first, particularly for developers who don't want to mod their existing router but want to run a debug/verbose kernel to help track down issues.

    Comes with 1.28.0502 MIPSR2Toastman-RT-N K26 USB Ext pre-installed, and everything is set to factory defaults.

    I can provide photos of it if asked (USB serial cable comes out the back of the unit; a small hole was drilled in the back and the cable fed through, connected to TxD/RxD/GND, and then hot glue used to hold the cable in place at tension/stress points to minimise any problems. Not rocket science. It's aesthetically pleasing).

    Looking to sell it for around US$60, and I'm willing to pay S/H if the destination is within the United States. If a developer is interested in it, I'll provide a slight discount.

    Thank you!
     
  2. koitsu

    koitsu Network Guru Member

    Sold. :)
     

Share This Page