1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Automatic Route to Verizon Servers

Discussion in 'Tomato Firmware' started by jbaker6953, Sep 26, 2010.

  1. jbaker6953

    jbaker6953 LI Guru Member

    When I loaded the 1.28 Victek mod, one of the first things I noticed was a couple of routes in the routing table.

    Code:    x.x.x.1    0    vlan1 (WAN)    x.x.x.1    0    vlan1 (WAN)
    These seem related to the opening of port 63681 under uPNP by my Windows 7 box.

    Does anyone know what this is?
  2. mstombs

    mstombs Network Guru Member

    I think those will be your DNS servers that were provided by the dhcp process on that WAN port - the entries in the routing table are "host routes". It may not have any impact on your current setup - but this will be needed in future when you may have multiple real or virtual wan interfaces.

Share This Page