1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

B/W limiter reboot loop in K26USB-1.28.0495.1MIPSR2-Toastman

Discussion in 'Tomato Firmware' started by Critical_, Feb 10, 2012.

  1. Critical_

    Critical_ Networkin' Nut Member

    I'm using 3 Asus RT-N66U routers with tomato-K26USB-1.28.0495.1MIPSR2-Toastman-RT-N-Ext. I found after setting up the B/W Limiter GUI to my liking the router goes into a reboot loop. The only thing that can rescue it is putting it into recovery mode and reflashing Tomato using the Asus utility. Interestingly, the reflashed router works fine even though the pre-reboot-loop configuration is still present (i.e. the B/W Limiter is still enabled... disabling it does not cause a reboot loop). I can consistently recreate this scenario on all 3 routers but I do not know what other information is needed to diagnose this further.
     
  2. kthaddock

    kthaddock Network Guru Member

    Have you done a REAL Nvram reset before and after flashing 0495.1 Fw ? 30-30-30 reset dosen't do the job !!!
    Administration => Configuration => Restore Default Configuration => Select: "Erase all data in Nvram memory Thorough"
     
  3. Critical_

    Critical_ Networkin' Nut Member

    Yes... I did a real nvram reset.
     
  4. kthaddock

    kthaddock Network Guru Member

    And you have speed setting to ~70 -80% of real down/up speed?


    Max Download Bandwidth (also used by QOS) kbit/s
    Max Upload Bandwidth (also used by QOS) kbit/s
     
  5. Critical_

    Critical_ Networkin' Nut Member

    Yes, I've done that as well. This problem sounds something similar (at least in symptoms) to what is described in this post.
     
  6. kthaddock

    kthaddock Network Guru Member

    Maby, what I remeber was that problem when turning on:
    "Default Class rate/ceiling for unlisted IP's" then router acts as you describe here.
     
  7. Critical_

    Critical_ Networkin' Nut Member

    Brilliant find. Thank you!

    I do have that enabled. I just searched for "Default Class rate/ceiling for unlisted IP's" and others have had the same problem in the past. I guess I will try it with that disabled. I should have posted a pre-reboot cycle screenshot of the web-based UI. It would have made diagnosing this much easier. My apologies.
     
  8. kthaddock

    kthaddock Network Guru Member

    Okey, test that and se if it solve your problem. :rolleyes:
     

Share This Page