1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

b4 firmware kills Wireless

Discussion in 'HyperWRT Firmware' started by OPaul, Jan 22, 2005.

  1. OPaul

    OPaul Network Guru Member

    After installing the b4 firmware my wireless connection started going down all the time. I went back to b3 and the problem went away. Anyone else experience this?
  2. vulcan4d

    vulcan4d Network Guru Member

    Routher froze on me twice, which it never did with the old firmware but that just could be coincidence ^^
  3. Avenger20

    Avenger20 Network Guru Member

    Unfortunately I can't replicate the problem. But if the poll reveals that 2.0b4 is more unstable than 2.0b3, I'll remove the P2P patch.
  4. Toxic

    Toxic Administrator Staff Member

    did you do a full reset on the wrt after you upgraded the firmware?
  5. OPaul

    OPaul Network Guru Member

  6. Jumbo

    Jumbo Network Guru Member

    The P2P is only the size of the NAT table ?

    I use 2.0b3 with "echo 4096 > /proc/sys/net/ipv4/ip_conntrack_max"
    and no problem.

    But with 2.0b4, i have lost of WiFi signal and must reboot.
  7. Avenger20

    Avenger20 Network Guru Member

    This one too :

    echo "1800 3600 120 60 120 120 10 60 30 120" > /proc/sys/net/ipv4/ip_conntrack_tcp_timeouts

    The second value "3600" (seconds) is the TCP idle timeout
    The TCP idle timeout was about 5 days! in the official firmware.

    If it's possible, please try if this might be the problem.
  8. tmour

    tmour Guest

    Hi all,

    I have the same problem, original firmaware 3.01.3 to HyperWRT 2.0b4, the connection was stable till 3 -5 min it drop again and very unstable. Always have to reboot the router to gain back the connection.

    I uses P2p and set the port fowarding and thing goes wrong till then. Before that I never have the connection problem but just the signal is weak. Can anyone help me out? :roll:


Share This Page