1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bandwidth Monitor by MAC Address

Discussion in 'Tomato Firmware' started by larynx, Dec 3, 2010.

  1. larynx

    larynx LI Guru Member

    I'm using Tomato Firmware 1.28, I was wondering if there is a way of displaying the bandwidth monitor split by mac addresses (or ip addresses/hostnames) instead of all together (or by interfaces).

    Thanks in advance.
     
  2. SoftCoder

    SoftCoder Addicted to LI Member

    Bandwidth per IP

    Yes check this out: ipt-parse
     
  3. CBR900

    CBR900 LI Guru Member

    I am new to linux staff

    Can you please make a video showing the steps and upload to youtube

    10x alot
     
  4. larynx

    larynx LI Guru Member

    Great SoftCoder, I'll try that.
     
  5. SoftCoder

    SoftCoder Addicted to LI Member

    I'll try to make a more simple installation process and once its done and tested I'll post here about it, but it will take a bit of time.
     
  6. occamsrazor

    occamsrazor Network Guru Member

    That looks like it would make a nice addition. Would this be just for "historical" data, or would it be available in some kind of live real-time view?
     
  7. Toastman

    Toastman Super Moderator Staff Member Member

    FYI - There's some new addition to Tomato's "qos-details" page and a new "qos-view transfers" page from Wes Gascoigne, which show the transmitted/received data per connection and the tx/rx rate per connection - in realtime. Inactive connections can be hidden. I think he may also be adding a checkbox soon to show the results only for a selected MAC or IP instead of the full list. You can check it out on my latest compile from the sites below (I compiled it only for the MIPSr2 routers though). This might be close to what you want? It ought to be possible to do all sorts of extra analysis later, too, adding up the connections would give total for a user, etc. Lots of possibilities!
     

Share This Page