blocking outgoing ports on Talisman

Discussion in 'Sveasoft Firmware' started by FalconYT, Jul 18, 2005.

  1. FalconYT

    FalconYT Network Guru Member


    Just installed Talisman yesterday and setup Link Logger to see whats coming in and goin out of my network.

    One of the outbound ports is netbios 137, I have turned it off in the access restrictions in Talisman but this appears to block incoming netbios requests. How would I block outgoing ports on Talisman???? I have two systems a MAC and a small NAS that appear to be sending netbios info outbound.

    Is this a feature in Talisman???

    I'm going on the info that Link Logger is saying if you see frequent outbound netbios requests, there's a good chance it could be a virus. Leave Netbios activity to you internal network and stop it from going outside. It's activity is pretty frequent... No machines have turned up any virus infections.

  2. FalconYT

    FalconYT Network Guru Member


    Most of the stuff listed was nothing to be concerned about. Over at Sveasoft the word is that the access restriction should take care of this. However they said they are re-doing the access restrictions section over, maybe for version 1.1???? Have to wait and see.

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice