1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Bndwidth Control Wrt54g

Discussion in 'DD-WRT Firmware' started by Zlatnia, May 13, 2005.

  1. Zlatnia

    Zlatnia Network Guru Member

    Hi guys

    I have 3 WRT54Gs and 1 WAP54g serving Internet at long range (4 km total) I have 6 wireless clients at different spots. I use DD-WRT pre5 Talismen (it's great) and Freya for the WAP54g. I put 1PC at the Internet gate to control the bandwidth and I want to pass it using some modules for the firmware to control the bandwidth in exact manner. 10 KB each user p.ex. no more or less, exact value each.

    Please help
     
  2. Guyfromhe

    Guyfromhe Network Guru Member

    here's what i'd do, there may be a way to do this right on the router, i've never tried nor do I run that firmware...
    you say you already have a PC between the last hop and the internet, i'd setup bandwidth limitation on that and allocate a block of IPs to each AP and have the AP filter out any other ips that shouldn't be used on that AP...
     
  3. Guyfromhe

    Guyfromhe Network Guru Member

    then setup speed limiting on the PC based on the IP of the remote machines.
     
  4. Zlatnia

    Zlatnia Network Guru Member

    10x for the help, but I'm allready doing the bandwidth control with the PC. I wanted to knof if there's some way to do it only within the router but the pc.
     

Share This Page