Bridge/Client mode failing

Discussion in 'Tomato Firmware' started by jicama, Jun 13, 2009.

  1. jicama

    jicama Addicted to LI Member

    My Tomato 1.25 WRT54G v3 works fine as an AP, but when I switch it into client or bridge mode it doesn't seem to work at all. Even though the other APs are right next to it, the Overview screen shows Signal Quality of <10, and the other APs don't show it in the list of active wireless clients.

    Any ideas?
     
  2. jicama

    jicama Addicted to LI Member

    Of course I found the answer right after I broke down and asked for help...I had wireless filtering set up on the Tomato router from when I was using it as an AP.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice