Bridged modem syslog route question

Discussion in 'Tomato Firmware' started by Kim K, Aug 29, 2013.

  1. Kim K

    Kim K Serious Server Member

    I have a Draytek Vigor 120 running in full bridge mode at My Shibby 110 AIO based E4200 has the "route modem IP" ticked and I can access the modem fine from clients.

    Is it possible to set it up so that the Draytek can "see" a syslog server at, i.e. on the E4200 network?

    I'm guessing I need to add some route on the Draytek.

    Thanks in advance.
  2. mstombs

    mstombs Network Guru Member

    It is possible even to give the modem internet access via the ppp tunnel which has endpoint in the router (for timesync, email reports etc) - you may have to set a default route on the modem to point to the router. You also have to add iptables rules to tomato firewall script to accept and forward messages received on the WAN Ethernet port (by default it only accepts replies to messages initiated from router). Such a config was discussed here many years ago.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice