Bridging in an Microsoft and Novell Environment

Discussion in 'Other Linksys Equipment' started by cdaga, Sep 29, 2005.

  1. cdaga

    cdaga Network Guru Member

    Hi Everyone

    I am using two WAP54G's in bridge mode connecting two network segments.
    Both segments contain IPX/SPX (Novell 4.x servers and clients and both ends) as well as Ip packets (Microsoft windows 2000 network with win2000 server for domain)

    Problem is

    When only the ms network is up (novell shut down) the bridges work fine no packet drops
    As soon as the novell servers are turned on the wireless link works for about 2-3 mins and then dies.

    I read some where that 802.3 raw frames cause this to happen ..

    IS there any solution ??
    (one solution is to use Layer3 managed switches at both ends to filter the packets .. but this is very expensive)

    Regards

    Cirvesh
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice