1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Can a Tomato router monitor a UPS?

Discussion in 'Tomato Firmware' started by Mango, Aug 3, 2011.

  1. Mango

    Mango Addicted to LI Member

    Can a Tomato router monitor a UPS to find out whether power supplied is by grid or battery, and how much battery life is remaining?

    I found an old thread from 2008 on this subject but was hoping for some new information.

    I don't have the UPS yet and am open to suggestions.

    Thanks :)
     
  2. Toxic

    Toxic Administrator Staff Member

    Firstly what is your UPS going to supply? if its a NAS/Server then most will support UPS via USB connections and log the event anyway.

    I setup my UPS to notify my NAS (via a UPS Daemon), which will turn off after x mins on battery power, - Also my NAS will broadcast (NUT) to any client, which i have a Client running on my PC called WinNUT which can also identify when the UPS has gone into Battery mode.

    check out: http://www.networkupstools.org/ for some info one software for monitoring UPS's

    When my UPS goes into battery mode, I know about it since the Audible Alarm sounds like every 10-20 Seconds. so really I dont need to notify anything apart from Critical services, ie my NAS on a RAID5.
     
  3. Mango

    Mango Addicted to LI Member

Share This Page