1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cannot upgrade

Discussion in 'Tomato Firmware' started by ikarusx3, Jan 18, 2008.

  1. ikarusx3

    ikarusx3 LI Guru Member

    Hey, big problem here,

    after flashing 1.14 tomato vpn mod, i did want to flash over to dd-wrt to check if mmc mod is working there. but after disabling jffs2, when i selected the firmware image and hit upgrade, after 2 seconds following message appears:

    jffs is disabled for sure, but something weird is happening there, because when i enable it it is showing 512.00 KB / 188.00 KB but /jffs dir is very empty...formatting results in the same values.

    nvram dump contains
    jffs2_format 0
    jffs2_on 0
    jffs2_size 524288

    may jffs2 size value be wrong? How can i clean the partition or reset it...i dont like being locked in :D

    all help is very appreciated!!!!!!!

  2. roadkill

    roadkill Super Moderator Staff Member Member

    yes it is because the upgrade program checks for SquashFS signature before upgrade
    now since I upgraded SquashFS to v3.0 the signature isn't the same which displays the error you encountered.
    now if any of you flashed mod versions 1.13/1.14 and want to flash something else you need to use the tftp method as stated in the first post.

    telnet/ssh into the router and make sure boot wait is on
    nvram show | grep boot_wait
    if it is on as it should be normally you can continue..
    connect your computer directly to port 1 on the router and give your NIC a static ip of
    then issue TFTP -i PUT <LOCAL FILENAME>
    while plugging the router into the power this must be done in the first 5 seconds the router boots up, so it will flash new firmware give it a minute or two the router will flash the firmware and reboot.
    a fix will be available soon.
  3. ikarusx3

    ikarusx3 LI Guru Member

    Okay thanks got it!

Share This Page