1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Can't access wired from wireless

Discussion in 'Tarifa Firmware' started by goochrules, Aug 18, 2006.

  1. goochrules

    goochrules LI Guru Member

    I have a WRT54GL v4.0 that I recently loaded the Tarifa b024 firmware on so that I could assign static DHCP addresses to my network devices. Everything in this and all other regards is working just fine, with the exception that I cannot access wired devices from wireless devices. I've fiddled with a bunch of settings (Gateway vs. Router, Access Point vs. Wireless Bridge, AP Isolation On vs. Off), but nothing makes any difference. Any suggestions?
  2. jchuit

    jchuit Network Guru Member

    It should work, I have this setup working here.

    The router has a MASK of , wireless and wired connections are on a separate vlan.

    If you like to inter-connect computers, the static dhcp should be in range of the network mask.

    example : You ip-number of the router is set to
    dhcp: The dhcp offers dhcp number from to
    static-dhcp: Choose ip numbers between to

    I hope this helps!
  3. goochrules

    goochrules LI Guru Member

    not really... I'm no good with subnet masks.

    My router's address is
    My three devices are at .11 and .12.
    Currently my subnet mask is (on the router and the devices).

    The wired devices can see each other, but not the wireless. I don't know if two wireless devices can see each other, I only have one, but it cannot see the wired devices.

    Thus, I don't see how the netmask is the cause here if the wired devices (on .10 and .11) can see each other, but I'm happy to be proven wrong: for this setup, what should it be?
  4. jchuit

    jchuit Network Guru Member

    Your WRT54GL setup is correct, all ip-numbers are in the to range.

    This means there is something wrong with the wireless-computer.


Share This Page