Can't get IP - is it bricked ?

Discussion in 'Cisco/Linksys Wireless Routers' started by datamile, Jun 7, 2005.

  1. datamile

    datamile Network Guru Member

    ok wrt54g v2.

    Installed freifunk whic went ok. Switched lan and wlan to dhcp, and I can't see anything, or get an ip address from anything that is connected.

    Once booted power, wlan, and lan lights are on.

    while booting I can ping 192.168.1.1 for a while, and does appear that I can tftp the firmware again.

    I put 2.02.07 linksys back on it, but nothing changed.

    Any ideas ?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice