can't get static DHCP working

Discussion in 'DD-WRT Firmware' started by geofftech, Dec 4, 2005.

  1. geofftech

    geofftech Network Guru Member

    I'm using DD-WRT v 2.3B 11/10/2005 on WRT V3. I can't seem to get static DHCP working. I went to administration -> services -> DHCPd is enabled. Used Domain is LAN&WAN.I entered my mac, IP address, and hostname. clicked save at the bottom and tried releasing and renewing the my IP with no go? What am I doing wrong. I used the DD-WRT wiki as my instruction source.
     
  2. DoC_DaR

    DoC_DaR Network Guru Member

    I would try factory reset, upgrade to 12/2 v23b, again facory reset. Only enable feature, input mac., name, IP. Set PC back to DHCP, reboot router and pc. Good Luck. PS I am using this version on a WRT54GS v2.0 and it works for me.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice