can't "see" networked computers (WRT54)

Discussion in 'Cisco/Linksys Wireless Routers' started by juglugs, Feb 9, 2007.

  1. juglugs

    juglugs LI Guru Member

    I have two PC connected to a WRT54. Both show up as connected, with excellent signal strength.
    Both are setup to use the same workgroup (Smiths) and using the WinXP wireless setup wizard, it show me that both computers were added.

    However, from either computer, I can not "see" the other one from explorer (network places) it only shows the computer I'm sat at....

    Any ideas??

    Mark
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice