1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cicsco 160NWRT router

Discussion in 'Cisco/Linksys Wireless Routers' started by Magdiel1975, Jul 12, 2012.

  1. Magdiel1975

    Magdiel1975 Networkin' Nut Member

    I have a little problem with my 160N router.. I have flashed the dd-wrt firmware and set it as a wireless repeater. It's working fine, but I am no longer able to access the setup page of this router.

    In the setup, I changed the IP address to 192.168.2.1 because my main router has 192.168.1.1. I can enter the setup page when I type 192.168.2.1 without any problems, but once I apply the repeater settings I have no access to that page any longer. I have tried resetting the router multiple times and starting from scratch, but no luck. I can however enter the setup page of the main router at 192.168.1.1 without any problems... Even if I get an ethernet cable and plug it to one of the ports of the repeater router and type 192.168.2.1 the page does not open. Any ideas?.. is this normal?
     
  2. Dark_Shadow

    Dark_Shadow Addicted to LI Member

    You need to hard reset the router and reconfigure using the ip 192.168.1.2

    192.168.2.1 puts it on a different subnet


    Sent from my iPod touch using Tapatalk
     

Share This Page