1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Cisco DSL config

Discussion in 'Other Cisco Equipment' started by Rattlehead, Jun 8, 2009.

  1. Rattlehead

    Rattlehead Network Guru Member

    Hi guys,

    Just a quickie can anyone give me an example or show me an example of a CISCO config, that uses a Dialer to connect to a DSL service via a bridged ADSL modem.

    i.e Line -------- DSL Modem in Bridge Mode -------- Connected to RJ45 FE port on CISCO.
     
  2. Rattlehead

    Rattlehead Network Guru Member

    Its ok I figured it out, for anyone who may need an example


    ip ips po max-events 100
    vpdn enable
    !
    vpdn-group PPPOE
    request-dialin
    protocol pppoe
    !
    no ftp-server write-enable
    !
    interface FastEthernet0
    no ip address
    speed 100
    full-duplex
    pppoe enable
    pppoe-client dial-pool-number 1
    !
    interface Vlan1
    ip address 172.16.96.105 255.255.255.252
    !
    interface Dialer1
    ip address negotiated
    ip mtu 1492
    encapsulation ppp
    dialer pool 1
    dialer-group 1
    ppp authentication chap callin
    ppp chap hostname test_ce@remote
    ppp chap password 0 t3stp4ss
     
  3. DocLarge

    DocLarge Super Moderator Staff Member Member

    Nice job, rattlehead.

    I was thinking about doing a video for this but this is right on the spot.

    Question, how did you determine your provider was using CHAP as opposed to PAP?

    Jay
     

Share This Page