Client and AP mode simultaneously

Discussion in 'Cisco/Linksys Wireless Routers' started by crawdaddy, Sep 16, 2006.

  1. crawdaddy

    crawdaddy Network Guru Member

    I was wondering, would it be possible for a single WRT to act as both a wireless client, and then an access point to redistribute the signal on a diffrent SSID. Looking through the tomato formware and screenshots, it looks like it may be possible, but I'm not going to load it up on a router right now to play with it to confirm it. Thanks
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice