1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

client mode

Discussion in 'HyperWRT Firmware' started by taichi, Feb 20, 2006.

  1. taichi

    taichi Network Guru Member

    Thibor13d == good stuff

    Just got a quick question.. does the client mode work as if I had a wireless card in my computer? If so, anyone know any settings I must change to make the router act as if its a wireless card?


    Thanks
     
  2. gaster

    gaster Network Guru Member

    Wireless Ethernet Bridge is what you need.
    Make sure DHCP is turned off on the client router and make sure to use the same exact SSID and pre-shared key and you should be good to go.
    Oh, and the second router needs to have it's own IP address.
    For example say the main router is 192.168.1.1 then use 192.168.1.2 for the second one.
     

Share This Page