1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Client to Gateway on CISCO RV-082 - connection simultaneously

Discussion in 'Cisco Small Business Routers and VPN Solutions' started by Claudio Oliveira, Jul 14, 2013.

  1. Claudio Oliveira

    Claudio Oliveira Reformed Router Member

    hi friends, i Need a help.

    i´m from Brazil, and I entered on this forum because i have one problem that is making me crazy.

    I have one Cisco RV082 router V2 with the last firmware, and I need make a VPN connection to two employees. I am configuring the option Client to Gateway like instruction in the Shrew site. Ok, I can access the vpn with client A, I can ping my subnet, is perfect.... but, when I connect to the vpn with client B, the client A disconnect automatic.

    If I reconnect the client A, the client B disconnect.
    I can´t connect the two clients in the same time.

    I tryed configuring individual VPN tunnels , but the same problem ocurred.

    Its posible connect two or more clients in the VPN on Cisco RV Series in the same time?

    someone have an idea how solve this issue?
    someone have a complete tutorial to the how configure VPN (Client to Gateway - Individual VPN) on cisco RV Series?

    Very, very thanks in advance... any help is very important to me.

    Sorry for my english, I´m studying :(.
     
  2. Toxic

    Toxic Administrator Staff Member

    are both clients (A and B) using the same IP Subnet at their own locations?
     
  3. Claudio Oliveira

    Claudio Oliveira Reformed Router Member

    Good Question.;)

    The router is not in production ambient... I`m trying in a Lab.

    The router subnet is 192.168.0.0 mask 255.255.255.0, the same configuration to real production ambient.

    The two clients are out of this range, the lab´s subnet is 172.16.120.0.

    I configured the Shrew client to utilize the virtual network card, and I configured the Ip with 192.168.30.0 and mask 255.255.255.0 to both clients. Is it the problem? I will configure client A to use 192.168.10.0 and client B to use 192.168.30.0... and I will test again...

    But, in the configuration mode Client to Gateway - Group VPN is posible connection simultaneously... how many simultaneously connections is posible on this configuration mode?? do you know?? I need only 3 or 4 connections ...

    thanks for a help.
     
  4. Toxic

    Toxic Administrator Staff Member

    not too sure on your model but the Cisco RV082 (v3) shows:

    IPsec
    100 IPsec site-to-site tunnels for branch office connectivity
    QuickVPN
    50 QuickVPN tunnels for remote client access
    PPTP
    5 PPTP tunnels for remote access
    Encryption
    Data Encryption Standard (DES), Triple Data Encryption Standard (3DES), and Advanced Encryption Standard (AES) encryption AES-128, AES-192, AES-256


    It does not list how many IPSec VPN Clients can hang off the RV082 though.
     
  5. Claudio Oliveira

    Claudio Oliveira Reformed Router Member

    Brother, you was right.

    Today I made new tests in my lab, and I connected successfully with 3 clients in the same time in the mode Client to Gateway Mode (Virtual Tunnel).

    I connected successfully to the cisco VPN Group with 3 clients in the same time, with the same information for autentication but with IP Address differents configured in the Virtual Network Card.

    the problem was really the ips configured in virtual network adapter

    Now I configured each client with an individual IP address.

    Thanks a lot for your help.
     

Share This Page