Connect more than one Wired PC to WRT54G(s) in client mode

Discussion in 'Sveasoft Firmware' started by jkp, Feb 17, 2005.

  1. jkp

    jkp Network Guru Member

    I read many times than it is not possible to connect more than one wired equipement to an WRT54G(s) configured as client (with satori).
    But it is possible!
    You just need to have a switch connected to the wan port. So you need to use another IP subnet, to delete default route toward WAN interface and add default route toward AP, and it's better to disable eggress NAT on the wan port using iptable.
    This solution is working very well. I'm using it for 3 months without any problems :
    3PC--wired--WRT54GS_client--802.11g--WRT54GS--wired--2PC
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice