Connect WAP54g --> WRT54G

Discussion in 'Cisco/Linksys Wireless Routers' started by bayviewdude, May 25, 2006.

  1. bayviewdude

    bayviewdude LI Guru Member

    I have a question on getting this to work on my setup. Currently my set up is as follows:

    Room 1: Cable Modem <====> BEFSR41 <===> WAP54G and PC 1

    Room 2: WRT54G <===> PC2, PC3, PC4

    Settings as follows:

    BEFSR41:

    IP: 192.168.1.1
    Gateway: 255.255.255.0
    IP Range 192.168.1.100 to 192.168.1.300
    Set as local DHCP server

    WAP54G:

    IP: 192.168.1.200
    Subnet: 255.255.255.0
    Gateway: 192.168.1.1
    Wireless mode = AP
    SSID broadcast enabled, WEP security OFF
    No MAC addres filters

    WRT54G:

    Firmware upgrade to DD-WRT
    Device is V1.0

    IP: 192.168.1.205
    Subnet: 255.255.255.0
    Gateway: 192.168.1.1
    SSID matches
    Wireless mode is Client
    WEP OFF
    DHCP server disabled

    Internet connection works (sometimes) but I don't seem to be getting IP address from the BEFSR41 on devices that are plugged into the WRT54g.
    Should DHCP work across a wireless "bridge"?

    Thanks for any and all help
     
  2. bayviewdude

    bayviewdude LI Guru Member

    Could the problem be dhcp leases?
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice