Connection Statistics

Discussion in 'MustDie Firmware' started by JusGoodFun, Apr 4, 2005.

  1. JusGoodFun

    JusGoodFun Network Guru Member


    Not sure if this is the right place to post or even possible but here goes.
    One thing that I would love to see is statistics and signal strength info on the status page between the AP and connected devices.

    I guess this is more simple to do this on the client side as the client is only concerned with its connection to the AP where as the AP is supporting many connections but I don't think impossible the data must be floating about in there somewhere.

    My bug bear is having a true client, you can see its sig strength etc but I run the WAP in bridge mode and therefore don't get any feedback on connection status etc...

    I just think with anything invisible such as RF signals, you need the tools to see whats going on to give you an idea where to look for problem resolution.

    I'm not sure is Must Die has anything like this, but I would love to know is it does and if not maybe it could be added to the "To Do List" for the guy who clearly has done his homework.

    Many thanks

  2. flinte

    flinte Network Guru Member

    i use the original FW 2.08 and if you set the WAP in Bridge mode or repeater you can see the site survey, too.

    type /site.asp behind the IP adress of your WAP. now you can see all available Networks in Range and you canm see the signal Quality, SSID and MAC adress!

    I hope it helps
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice