contact my wrt54g in client mode to Senao that acts as AP

Discussion in 'Cisco/Linksys Wireless Routers' started by dacom386, Feb 3, 2005.

  1. dacom386

    dacom386 Network Guru Member

    :?: I have installed de latest Sveasoft firmware 6RC6a on my WRT54G V1 , I set my WRT54G to client mode in have enabled wep and SSID , but still i can't connect to the Senao AP, I have puth in the same information into my WRT54G as i have don into my 4 WET11 and they have no problem to connect to the Senao AP
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice