Correct way to flash?

Discussion in 'Cisco/Linksys Wireless Routers' started by lencuff, Oct 26, 2006.

  1. lencuff

    lencuff LI Guru Member

    After toasting a Netgear router during the flash, I don't want to do the same with my WRT54GS!
    What's the correct sequence to do it? I've heard that it's better to do it in Safe mode/networking and disconnect all except my PC?

    What about reverting to default, power off etc?
    Apologies if this has been covered before. I downloaded the manual last night but that only shows the firmware upgrade screen and nothing else!

    TIA
     
  2. howardp6

    howardp6 Network Guru Member

    You should revert to factory defaults before flashing the firmware updated from a wired connection only.
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice