1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Corrupted factory defaults (?)

Discussion in 'Cisco/Linksys Wireless Routers' started by sune, Jun 21, 2004.

  1. sune

    sune Network Guru Member

    I have a WRT54G v1.1 box and use the recent (official) Linksys 2.02.8-security firmware.

    It works fine, but if I load the "factory defaults" from the admin pages, it kills my ethernet LAN access completely. WLAN works however, so I can access the config pages that way.

    After a lot of resetting, reflashing and so on, the only working cure I've found so far, is to load one of Sveasofts "satori" builds (which in some magic way fixes the ethernet lan), and then "downgrade" again to the regular linksys firmware.

    Not much of a problem since I rarely need to reset or load the factory defaults anyway (also I can power cycle the WRT54G without any issues), but if anyone know a simpler way to solve this problem, or restore correct factory defaults, I would be happy.

    Tia

    /Sune
     
  2. Toxic

    Toxic Administrator Staff Member

    I n=know sveasoft does have a "factory default" firmware which resets ALL settings to default. then you reflash with the firmware u want.

    I dont though know is it is available to public or subscribers only
     

Share This Page