1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

DD-wrt to Tomato- wnr2000v2 help

Discussion in 'Tomato Firmware' started by priyen, Oct 27, 2011.

  1. priyen

    priyen Networkin' Nut Member

    So i have DD-WRT on my WNR2000v2 router. Trying to flash tomato firmware
    I have a small issue, when ever i try to flash, something goes wrong:
    1st Attempt:
    1. Restored default settings on router via dd-wrt web interface. (router then rebooted)
    2. Telenet'd nvram get http_passd
    ( and i got the pass successfully)
    3. closed telnet
    4. opened up firefox, went to the gui and select the firmware file (i renamed the extension to .bin , as instructed on tomato wiki.)
    5. Got the dd-wrt 300 second countdown, i look at my net meter, it shows 0Kb/sec uploading...
    6. "Upgrade complete"
    7. I go to the gui, ITS STILL DD-WRT.
    p.s. during this whole process, the router power light was alternating between green and orange
    2nd Attempt:

    1. Restored default settings on router via dd-wrt web interface. (router then rebooted)
    2. Telenet'd nvram get http_passd
    ( and i got the pass successfully)
    3. closed telnet
    4. opened up INTERNET EXPLORER, went to the gui and select the firmware file (i renamed the extension to .bin , as instructed on tomato wiki.) This time the greenbar on internet explorer was slowing going ------>, but stopped around 1/3 of the way, 33%
    5. Got the dd-wrt 300 second countdown, i look at my net meter, it shows 0Kb/sec uploading...
    6. "Upgrade complete"
    7. I go to the gui, ITS STILL DD-WRT.
    ---------------------
    Am i doing something wrong, each time i fear bricking my router... How do i properly go to tomato??
     
  2. xtacydima

    xtacydima LI Guru Member

    Which specific version of Tomato are you trying to load?
     
  3. priyen

    priyen Networkin' Nut Member

    im trying to load: tomato-K26-1.28.9054MIPSR2-beta-Mini
     

Share This Page