ddwrt to tomato = hmmmm

Discussion in 'Tomato Firmware' started by megafrenzy, Dec 1, 2007.

  1. megafrenzy

    megafrenzy LI Guru Member

    I have a WRT54g v1.0, running ddwrt for long time now, decided to try tomato on this old unit. Followed directions, ended up bad, no gui page. I can get it to respond to pings sometimes, tried numerous times to tftp with various timing, no good. I can also telnet into it.

    unknown login: root
    Password:


    Tomato v1.11.1217


    BusyBox v1.2.2 (2007.10.29-21:46+0000) Built-in shell (ash)
    Enter 'help' for a list of built-in commands.

    #

    At this point I am unsure what I can do, perhaps clear the NVRAM (what command is that)? Once I get in, it only works for a short while. I'm reluctant to do the pin shorting, but I can build a JTAG cable.

    I'd appreciate any advice.
     
  2. u3gyxap

    u3gyxap Network Guru Member

    mtd erase nvram
     
  3. roadkill

    roadkill Super Moderator Staff Member Member

    on Tomato it is mtd-erase -d nvram to erase nvram
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice