1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

debricking a wrt54g V8 with Jtag cable ???

Discussion in 'DD-WRT Firmware' started by qubo, Nov 21, 2008.

  1. qubo

    qubo Addicted to LI Member

    HI. I want to reflash my WRT54G version 8, it was bad flashed. so I had to buy a Jtag cable.
    I downloaded the debricking pack but I dont know if It can be done with version 8 since is not linux, the debricking pack has until version7 not 8 what is what i need.

    someone could drive me in the right direction since I am stuck trying to debrick the WRT54G v8.

    other question. it is necesary to solder th jtag pin with the router ? it is not possibe to only put firm without movement to avoid solder ?

Share This Page