1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Device connected to eth1 but IP address blank?

Discussion in 'Tomato Firmware' started by mvsgeek, Jan 13, 2014.

  1. mvsgeek

    mvsgeek Addicted to LI Member

    My Main router's Device List shows an Apple device - its MAC address is 8C:2D:AA:XX:XX:XX - connected to eth1, but its IP address is blank. I'm pretty sure it's connected, because the TX/RX column values are constantly changing. A couple of other devices connected to eth1 have valid IP addresses. Most of the clients on the network connect via secondary WDS AP's, so they show up in Main's Device List as br0 connections with valid IP addresses. Any idea why this one eth1 device shows no IP?

    Main router is Asus RT-N16, Tomato Firmware v1.28.7483 MIPSR2-Toastman-RT K26 Std

Share This Page