dhcp for wireless only

Discussion in 'Tomato Firmware' started by rs232, Jul 13, 2011.

  1. rs232

    rs232 Network Guru Member

    Is there any way to have DHCP serving IPs to wireless clients only (no ehternet)?

    I've tried few DNSMASQ parameters but so far no luck.
  2. teaman

    teaman LI Guru Member

    You might want to have a look at Tomato VLAN-GUI: it allows you to create up to 4 LAN bridges, each with it's own IP/network and DHCP server settings. Also, access/traffic between LAN arms can be configured via web interface (i.e. you may want to prevent WLAN clients from accessing wired LAN by default, but allow them to access a printer, etc...).

    If you're curious about how the web interface looks like, here's some screenshots taken from my WRT54GL v1.1:

    If you have a similar/compatible router, here's the link to download the firmware image I've been using on mine (the very same router the screenshots mentioned above were taken):

    Discussion thread:

    Source code:

  3. vader1000

    vader1000 Networkin' Nut Member

    Have you found any answer to this question other than reinstalling a different firmware? I have the same issue. I don't want to have to start over for just 1 simple option... I need to disable dhcp on the wired side. This is especially true for me because I installed and configured 3 of these radios over a year ago and it took me over a week. I already invested the time to get things set properly - except for this apparently. The issue has not become a problem until now.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice