1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Did I BRICK my WRT54GS?? ARRGGGH!!!

Discussion in 'Cisco/Linksys Wireless Routers' started by calvin trager, Feb 23, 2007.

  1. calvin trager

    calvin trager LI Guru Member

    WRT54GS V 1.0

    After I flashed my Linksys firmware with the "dd-wrt.v23_mini_wrt54gs.bin," the "CONTINUE" button showed up, I did NOT wait 5 minutes.

    Having flashed my router before with third party firmware before, I didn't have this problem.

    Whatever I use to try to access the router GUI, I've tried:

    192.168.1.1 and 192.168

    Any ideas greatly appreciated.

    Thanks
     
  2. Mastec

    Mastec Network Guru Member

    Did you do the 30 second reset before and after the flash?
     
  3. calvin trager

    calvin trager LI Guru Member

    Brick

    I didnt do a 30 second reset before the flash.

    The 30 second reset after??? do you mean press the reset button on the router???, didnt to that either, my internet connection still works using the router, does that indicate anything??

    I did power cycle for about 60 seconds and rebooted my pc...

    SHould I do the "hold the reset button and plug in the power plug" to do an alternate reset option I read elsewhere ????

    thanks for the reply and suggestions
     
  4. calvin trager

    calvin trager LI Guru Member

    Finallygot The Router Control Panel

    I did the hold reset and plug in power cord, and when I started my browser, there was the DD-WRT panel

    YEA!!!
     
  5. Mastec

    Mastec Network Guru Member

    Glad you got it working :)
     

Share This Page