Disableing SSH in CLI?!?

Discussion in 'DD-WRT Firmware' started by XCOM7, Apr 20, 2005.

  1. XCOM7

    XCOM7 Network Guru Member

    Ok guys I was working with SSH so I had it enable now that I am dun with I try to disable it and it just stay open.
    What is the CLI command to disable ssh?
  2. XCOM7

    XCOM7 Network Guru Member

    Any body?
  3. tl511

    tl511 Network Guru Member

    Just look for the running process (ps -ef). It should be running as dropbear. Then kill the pid. THat takes care of it temporarily. Why not just disable it through the GUI?
  4. XCOM7

    XCOM7 Network Guru Member

    Cause I disable it thru the GUI but the port stay close not stealth... So is visible to the public thru a port scann. even worst when enable the port is wide open. They should be a rule where you can enbale it in the LAN or WAN or BOTH.
  5. XCOM7

    XCOM7 Network Guru Member

    Any ideas? Why does SSH shows open from the wan side?
  6. RMerlin

    RMerlin Network Guru Member

    Did you scan your WAN interface from the inside or the outside of your LAN? I just checked on my home router from work, and my SSH port is stealthed (a telnet attempt failed after the connection timeout expired like any stealthed port would - an active connection reject would have immediately failed)

    It sounds to me like you're scanning from the inside, in which case the loopback will disrupt your scan results.
  7. XCOM7

    XCOM7 Network Guru Member

    Sorry but I know better ;) I scann from the WAN side I can post results and screenshoots if need it to pin point the source of these issue.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice