Disabling LAN DHCP but keeping Wireless DHCP

Discussion in 'HyperWRT Firmware' started by SprkFade, Jun 28, 2006.

  1. SprkFade

    SprkFade Guest

    I was wondering if it was possible to disable DHCP on the LAN side/ports but keep it enabled for Wireless clients only. I have a wrt54gs connected to an existing network that uses static IP addresses but I'm using it as a gateway for wireless clients with Static DHCP. So I'm trying to keep the DHCP for the wireless but disable it for any PC that connects to the network via a cable.

    I couldn't find an option in the HyperWRT firmware but maybe I missed it. Any help would be greatly appreciated.
     
  2. Thibor

    Thibor Super Moderator Staff Member Member

    it's not an option. perhaps there is an advanced dnsmasq command, but that would involve breaking the bridge and doing dhcp on a seperate vlan for wireless only.
     
  3. digitalgeek

    digitalgeek Network Guru Member

    DHCP?

    If you are setting static IP's on your wired clients, what does it matter? as long as you open the right ports between the wired and wireless
     
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice