1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Dishnetwork VIP622 not connecting to router

Discussion in 'Tomato Firmware' started by mikew, Oct 9, 2009.

  1. mikew

    mikew Guest

    My problem is, I can not connect to the router with the VIP622 when the router has tomato loaded, but it will connect with no problem with the stock Linksys firmware loaded.

    My setup is as follows:

    WRT54GSv4 connected to the net via PPPoE. Two home computers connected to the the router, one via ethernet and one using wireless. Both connect with no problem. The VIP622 is connected via wireless to the router with a Dlink DWL-2100AP running in client mode. When I load tomato v1.25, the DWL-2100AP connects with the router with no problem, but the VIP622 cannot seem to get an IP or DNS info from the router. The router does see the VIP622, because the MAC address of the VIP622 will show in the device list while the box is trying to connect and the log shows an IP is being offered, but the VIP622 can not get a final connection. Once the VIP622 gives up, its MAC address drops from the device list. Both firmwares are set up with DHCP and WPK Personal TKIP security.

    I would like to run tomato to get better QoS control while running utorrent.

    Thanks in advance for your help,


Share This Page